Track spotlight track butt joint installation method

Track spotlight installation method:

Guide rail, guide rail lamp holder, lamp holder fixed on the bracket, lamp holder installed on the lamp holder. There are two conductive plates at the top of the guide rail and a long slot at the bottom of the guide rail. On the light stand is the roof, which has two raised spring terminals. The top of the light frame is arranged on the track, and the two elastic ends of the vehicle roof respectively contact the two conductive plates on the track.

To install the track, if the top is directly made of wood or iron keel, you can directly drill holes, and then the track can be installed directly. After drilling the positioning holes, install the rail fixing screws. Remove the power protection cap on the top of the installed track, connect the power cord with a tool, and pay attention to the safe use of the tool. Use the clamp to flatten the base of the track light, align it with the groove in the track, insert the base of the track light into the slideway, apply a little force, and after tightening the threads, unscrew the handle that rotates the clamp head, and then tighten it. Swipe left and right to see if it is fixed. Installed and turned on, according to the position of the projection target, adjust the horizontal and vertical angles of the track light to ensure that the track light can fully and effectively project the object to be illuminated.

The method of docking the two-track spotlight track: it is more troublesome to install the track light. The home ceiling is made of gypsum board, which can be fixed by aircraft expansion plugs. In some living rooms, the lower hanging ribs need to be punched, and then the chuck of the slide light base is screwed flat. Open the rail cover and remove the wiring cover. For the convenience of installation, you can connect a longer and better power cord at the wiring. When installing the track, if it is a roof, directly choose a wooden board. If it is an iron keel, you can directly drill the nail hole, so that the slideway can be directly connected. Align the groove of the slideway, put a little force in the slideway of the slideway lamp holder, so that it can fit together, and unscrew the handle that rotates the chuck, and screw it to a fixed position. After installing the spotlight, power on the spotlight, turn on the switch, and observe whether the lamp can work normally. When it can work normally, the irradiation angle of the spotlight can be adjusted.